|
THE
ENTERPRISE
IS A MONAURAL 300 WATT POWER AMPLIFIER BASED ON THE CITADEL, THETA'S
MOST POWERFUL AMPLIFIER, AND THE DREADNAUGHT II: IT BENEFITS FROM
THE KNOWLEDGE, RESEARCH AND DEDICATION THAT TEAM
THETA BROUGHT TO THOSE SUPERLATIVE DESIGNS.
Enterprise has been created
to power superb two channel music reproduction systems, as well
as delivering abundant power to home theater systems, to faithfully
recreate the vast spectrum of soundtracks.
 The
heart of the Enterprise is its
fully-balanced differential, zero-feedback circuitry,
with meticulously selected solid-state devices throughout. We scrutinize
the selection to optimize component parts in each and every stage,
and for the performance of the amplifier as a whole.
The sound is similar to the mighty Citadel amps in
veracity and intimacy with the musical experience, and in the prospect
of movie performance that will make your home theater your favorite
movie palace.
The audio board is a 4-layer glass-epoxy
circuit board: 1 layer each for positive and negative supply lines;
1 layer for ground plane; 1 layer for signal path.
Enterprise's transistors are the
same ultra-fast devices that help give Citadel and Dreadnaught II
their superlative sonic signature.
Enterprise uses the same bridge
rectifier, mother board, and capacitive banks as Citadel!
Power
Enterprise is an exercise in delivering tremendous
power with absolute integrity. The Enterprise output power supply
uses a single, high-current 480 watt toroid transformer, which feeds
an ultra-fast/soft-recovery 35 Amp full bridge rectifier. The power
supply lines are then filtered by two capacitive banks totaling
a hefty 80,000uF. The sonic result of these very clean supply lines
to the output transistors is exceeded only by the Citadel on which
Enterprise is modeled.
 
Highlights
Nominal power rating:
300 Watts into 8 ohms, 500 Watts into 4 ohms (What it really does:
350 into 8, 525 into 4)
Ultra-fast/soft recovery
bridge rectifiers for regulated and high-current supplies
Gold-plated RCA and locking
XLR input connectors
OPTIONAL: Custom-made, high-pressure
contact Delrin/Rhodium plated output connector with Cardas 9 gauge
Litz/Teflon wire, tool provided for tightening
OPTIONAL:
Second output connector for bi-wiring, either Cardas or high-pressure
contact type
User accessible rear panel rail fuses
Rear panel LED indicators
for fuses and thermal overload
Rear panel jack for remote
control of Mute/Standby
RS-232 connections for
computer controls and status information
Control tower button for
Mute/Standby; LED indicators for Mute/Standby and Thermal Overload.
|